Epoxy Resin Drain Boards

Increase productivity and efficiency with epoxy resin drain tops. Chemtops offers this unique epoxy resin worksurface to improve performance in lab sink areas. Liquid control begins with the epoxy drain board’s raised outer marine edge. This raised safety barrier surrounds the worksurface preventing most spills and splashes from overflowing onto lab technicians, case work and lab flooring. The epoxy resin drain top surface directs liquids toward the sink with a slight pitch. This increases the height of the containment barrier around the sink’s splash zone. These tops incorporate a raised rib drain board design. These durable ribs elevate laboratory glassware above the worksurface which increases air flow in and around wet items and reduces drying times. The smooth rib surfaces are designed to eliminate absorption and ease clean ups. Thorough cleaning prevents chemicals from mixing in the sink area and reduces the staining typical with machined drain grooves. With good housekeeping practices, the epoxy resin draintop can retain its good looks for the life of the lab!

Lab grade faucets, eyewashes and other lab accessories can be mounted on the large elevated rear deck. The elevated deck keeps laboratory fixtures above the wet area protecting them against corrosive chemical and moisture damage and eliminates the possibility of standing water seeping into the sink cabinet through the fixture hole (before you order lab faucets please ensure sink rim clearance).

Classic Drain Top Sizes
Classic drain tops are available to meet many standard size requirements. Back rails can be trimmed to accommodate additional worksurface dimensional requirements (see table below).

Edge Options
Drain Tops come standard with either a 1/8” bevel or a 1/4” radius exposed edge. These attractive worksurfaces can be used throughout the lab at the end of islands, peninsulas and in wall runs in-line with other epoxy resin tops.

Drop In Sinks
Epoxy Resin drain tops are excellent platforms for our Epoxy Resin drop in sinks. Any sink can be specified so long as the outer rim dimension plus the sink cutout’s 1/8” [6mm] bevel fit into the drain top sink area. Double Drop in sinks require a 1” [25mm] worksurface strip between the two installed sinks.

Colors Options
Specify any of standard epoxy resin colors including Black, Gray, Pewter, Pearl, Pacific Blue and Forest Green. Many additional custom colors can be created on a special order basis.

Drain Top Configurations
Center sink drain tops with dual drainboards and single drainboard units with sinks offset to the left or right are available.